
ServicesGutter Repair
Gutter Repair in Mount Pleasant
Drips at the corners, a run pulling off the fascia, water spilling over the front edge: most gutter trouble can be fixed without replacing the whole system. We find the cause, show you what we found and give you a clear repair plan.
When repair is the right call
Gutters usually fail in small, specific places. A seal dries out at a corner. A hanger loosens and the run starts to sag. An end cap pops off after a heavy storm. If the rest of the gutter is sound, fixing those spots is the sensible, lower-cost answer, and that is what we recommend.
We also tell you plainly when repair is not worth it. If the metal is rusted through in several places or the runs are too small for your roof, we will say so and explain what gutter installation would involve, so you can decide with the full picture.
Repair matters for more than looks. Water that spills over a broken gutter lands right beside your foundation and soaks the soil under your home. That extra moisture can raise humidity in a crawlspace, and damp air is harder and costlier for your air conditioning to handle through a long humid summer.
What our gutter repair covers
Resealing leaking seams and corners
We clean the joint down to bare metal, remove old failed sealant and apply fresh gutter sealant so the corner stays dry.
Rehanging sagging runs
Sags trap standing water and pull on the fascia. We replace worn spikes and loose hangers with new hidden hangers spaced closer together, then reset the run to hold its shape.
Correcting the pitch
A gutter needs a slight, steady fall toward the outlet. When water pools in the middle or overflows at one end, we adjust the slope so it drains instead of sitting.
Replacing damaged sections and end caps
Dented, cracked or rusted pieces are cut out and replaced, and missing or loose end caps are refitted and sealed.
Checking the fascia behind the gutter
We look at the board the gutter hangs from. If it is soft or rotted, we show you photos before anything goes back up, because new hangers will not hold in wet wood.

Signs your gutters need repair
- Drips at joints and corners
- Water falling from a seam during rain, or rust streaks and stains below a corner, means the seal has failed.
- A run that dips or pulls away
- A visible sag or a gap between the gutter and the fascia points to loose or failed hangers.
- Water spilling over the front edge
- Overflow in light or moderate rain often means the pitch is off or a section has bent out of shape.
- Peeling paint or stains on the siding
- Repeated splashing from a leaking gutter wears down paint and leaves dark streaks on the wall below.
- Puddles or washed-out soil by the foundation
- Pooled water or eroded mulch along the house tells you rain is coming off the roof in the wrong place. After the frequent summer downpours here, it is worth a quick look around your home.
How a repair visit goes
- 1
A free consultation by phone
Describe the drip, sag or overflow and which side of the house it is on. From there we book a time that suits you to come out and see it in person.
- 2
Inspection and photos
We walk the full gutter line, not just the spot that prompted your call, and photograph anything that needs attention so you can see it for yourself.
- 3
A clear written estimate
You get a line-by-line estimate that separates what needs fixing now from what can wait. Nothing starts until you approve it.
- 4
The repair and cleanup
We protect your plants and walkways, make the repairs, then run water through the gutters to confirm they drain properly. Old parts and scraps leave with us.
What affects the cost of gutter repair
Most repairs cost far less than new gutters, but the price depends on what we find once we are up on the ladder. We explain each line of the estimate before any work begins, so there are no surprises on the final bill.
- How many problem spots
- Resealing one corner is a short job. Several leaking joints and a sagging run across the back of the house take more time and materials.
- Height and access
- A single-story eave is quick to reach. Two-story walls, steep roofs or gutters above decks and landscaping need more setup.
- Condition of the fascia
- If the board behind the gutter has rotted, it has to be addressed before the gutter can be rehung securely, which adds to the job.
- Gutter material
- Aluminum, steel and copper each need matching parts and fasteners. Mixing metals invites corrosion, especially in salty coastal air, so we match what you have.
Gutter repair questions
- Can you just fix the one leaking spot?
- Yes, if that is all that is wrong. We will still look over the rest of the system and point out anything else we notice, but you choose what gets done. We never bundle in work you did not agree to.
- How do I know whether to repair or replace my gutters?
- If the problems are limited to a few seams, hangers or sections, repair makes sense. If rust has eaten through in many places or the gutters overflow because they are undersized, replacement is usually the better value. We give you our honest view either way, with photos to back it up.
- Will fixing my gutters really help with energy costs?
- It can help indirectly. Water dumped next to the foundation keeps the soil and crawlspace damp, and humid air takes more work for your AC to cool and dry. Repairing the gutter keeps that water away from your home, which supports a drier, more comfortable house.
- How long does a typical repair take?
- Most repairs are finished in a single visit. Larger jobs, such as rehanging several long runs or replacing rotted fascia first, can take longer, and we tell you the expected time in the estimate.
- Do I need to be home during the repair?
- Not usually, since the work is all outside. We just need access around the house and a way to reach you if we find something unexpected. We will call and show you photos before doing anything beyond the approved estimate.

Stop the drips before they cost you more
Tell us what your gutters are doing and we will come take a look. You will get a straight answer on what needs fixing and what it will cost.